<p>Hi Guys, I need a custom design job please.</p>

<p>&nbsp;</p>

<p>It is a double ring set, which stack and fit neatly together. Each ring will have a single east-west marquis diamond. The 2 rings will ultimately need to fit snugly together, with the 2 marquis off-set from each other, similar to as shown below (except fitting seamlessly together).</p>

<p>&nbsp;</p>

<p>So, what I&rsquo;m after is some rendered images of the rings, from a few different angles/perspectives, to show to the client, so that they can make further modification from the initial viewing.&nbsp; I suspect there may be a few iterations.</p>

<p>&nbsp;</p>

<p>We have the stones already; 2 marquis diamonds, of dimensions:</p>

<p>8.32mm by 5.22mm (this one is currently set in an existing ring; see image below)<br />
6.66mm by 3.52mm<br />
(these dimensions are &lsquo;reasonably&rsquo; accurate)</p>

<p>&nbsp;</p>

<p>8.32mm by 5.22mm currently set</p>

<p>&nbsp;</p>

<p>Width of each band is to be approx. 2.7mm</p>

<p>Depth of each band is to be approx. 1.5mm</p>

<p>Ring size is Australian size: P</p>

<p>Yellow 18ct gold. (client mentioned them may want the stone setting to be white gold and the band to be yellow, but we&rsquo;ll just go with all yellow gold now, for the first iteration please)</p>

<p>&nbsp;</p>

<p>The setting needs to be a bezel, which is appox 2mm wide, and the bezel part that goes around the pointed ends of the marquis needs to be &lsquo;rounded&rsquo; rather than a sharp point.</p>

<p>&nbsp;</p>

<p>Profile of the band to be similar to this:</p>

<p>If this could also be done as a &lsquo;comfort fit&rsquo;, then that would be okay.</p>

<p>&nbsp;</p>

<p>Side view; solid bezel setting:</p>

<p>&nbsp;</p>

<p>Each band stamped 750</p>

<p>Example of &lsquo;snug&rsquo; fit.</p>

<p>The 2 rings will ultimately need to fit snugly together, similar to the example above (although with the two east-west marquis off-set from each other)</p>

<p>&nbsp;</p>

<p>I&rsquo;m thinking that we might just do the first ring, with the larger stone, first, and then once the client is happy with the look of that one, then we can do the smaller stone in the second ring. This might make it easier to do the few design iterations on the one ring only, before doing the second one.&nbsp; The setting for each stone will be the same, so we just need to get it right for the one at the moment, and once the client is happy, we&rsquo;ll duplicate the setting for the second stone/ring please.&nbsp;</p>